Getting Started > Technical Support/Testing
Testing image sizes
GrahamB:
Here is my original image, width 1000, height 667:
Here is the same image with size modified by adding "width=500 height=333" after "[img" at the start of the code
Like this...
img width=500 height=333]http://i1287.photobucket.com/albums/a621/GrahamB2013/IMG_5000a_zpsofuagpnp.jpg[/img]
(I omitted [ at the start so the software treats this line as text)
Note- the width and height figures must stay in the same proportion as for the original picture, or it will come out distorted, like this (width 500, height 600)
bml87:
Very useful! Thanks :D
Klickteryx:
check
tahra:
I took the liberty of using your pic, GrahamB ;)
You can specify the width only (that was my doubt), hence sparing you the need to figure out the proper height ;)
--- Code: ---[img width=500]http://i1287.photobucket.com/albums/a621/GrahamB2013/IMG_5000a_zpsofuagpnp.jpg[/img]
--- End code ---
if you wrap the code with the [ code ] tag (minus spaces), it doesn't get "interpreted"
bml87:
--- Quote from: tahra on January 17, 2018, 10:16:04 ---I took the liberty of using your pic, GrahamB ;)
You can specify the width only (that was my doubt), hence sparing you the need to figure out the proper height ;)
--- End quote ---
Great! Thanks, Tahra :) !
Maybe a Mod should stick a Topic like "Read this before posting images" in the Diorama Forum? Handy for new members :)
Navigation
[0] Message Index
[#] Next page
Go to full version