PlaymoFriends
Creative => How-To => Topic started by: Rasputin on September 06, 2008, 18:37:23
-
Ok with these new sets some may want to use the walls as a freestanding piece and not use it as a storage or mobil set .
First get a small slotted screwdriver .
With your hand holding the set use the screwdriver to pop out the corner tabs . Keep holding pressure on the backing plate to not allow the tabs to snap back in .
(http://img441.imageshack.us/img441/513/p1010011fn3.jpg) (http://imageshack.us)
with the screwdriver gently pry the upper center tab out and the rear plate will release
(http://img377.imageshack.us/img377/2572/p1010013eo6.jpg) (http://imageshack.us)
(http://img441.imageshack.us/img441/8592/p1010014xc3.jpg) (http://imageshack.us)
The backing plate has the two tabs on the upper corner and the one in the upper middle and the two bottom tabs that act like a hinge when the uppers are released
(http://img402.imageshack.us/img402/8229/p1010016us9.jpg)
Note : the 4776 was a bit harder do to the configuration of the set . On the 4775 I was able to do it with out a screw driver and simply grasp the handle w/ one hand and spread the upper corner out w/ the other and twist the back off . ( it has been over 100 degrees here so the plastic is warm )
(http://img135.imageshack.us/img135/7173/p10100031qx6.jpg) (http://imageshack.us)
-
Great photos Rasputin! Thank you for the info.
Gepetto
-
Thanks, Ras ...
I'm going to make an attempt at disassembling 4774 (http://www.playmofriends.com/forum/index.php?topic=2553.msg28867#msg28867)..
Hopefully, it will be as easy as you've made it appear to be ... :o
I'll let you know what happens.
All the best,
Richard